تطوير الهيوماكس بهيوماكس آخر وبدون كمبيوتر (E)

[موفق]

*Download Instruction for IRD to IRD. ( F1 / F1-CI / F1-VA / F1-VACI )

1.Connect the two receivers using a serial cable.
2.The two receivers must be of the same type, i.e. F1-CI to F1-CI.
3.Switch on the master receiver, leave the slave receiver switched off.
4.The master receiver is the receiver you want to transfer data from.
5.Go to the STB/IRD Status menu on the master receiver.
6.Press the TV/Audio button on the front panel of the master receiver.
7.If there is no such button, then press the up arrow button on the front panel of the master receiver.
8.Press the "i" information button on the remote control.
9.Press the soundtrack button on the remote control (speaker with a question mark).
10.Press one of the following buttons on the remote control:
- press "1" if you want to transfer data only (bouquet and channel list).
- press "2" if you want to transfer the loader.
- press "3" if you want to transfer the software.
11.You will now see a message "UP-?"on the front display of the master receiver.
12.Switch on the slave receiver and the download should begin.
13.You will see "d-00" with the numbers increasing on the front display of the slave receiver.
14.You will then see "P-00" with the numbers increasing.
15.When the transfer is complete, you will see "End" on the front display of the slave receiver.
16.It is now safe to switch off the receivers (do not switch either receivers off while the transfer is in progress.

====================================================

*Download Instruction for IRD to IRD. ( ALL OAK Models )

Please follow these instructions step by step:

1. Connect the two receivers using a serial cable.
2. Switch on the master IRD, leave the slave IRD switched off.
3. The master IRD is the IRD you want to transfer data from.
4. Go to the STB Status menu on the master IRD.
5. Press "Red" key ® “Green” key ® “Yellow” key ® “Blue” key ® “White” key using the RCU in sequence.
6. Press one of the following buttons on the remote control depend on what you want to transfer :
- Press "1" if you want to transfer the loader (change loader s/w)
- Press "2" if you want to transfer application software.
- Press "3" if you want to transfer the setting data (copy Main menu setting value).
- Press "4" if you want to transfer Information data only (bouquet and channel list).


------------------
تبسمك في وجه أخيك صدقة

[somaia]

اوجه الشكر الى الاخ موفق
ولكن لوكان الشرح باالعربي موكان احسن
------
تحياتي
-----


------------------
سمية وبس